KMH Forklift Safety

Safety First

With over 145,000 people working in over 7,000 warehouses the potential for hazards is staggering. From the use of unsafe forklifts to inadequate fire safety the fatal injury rate for the warehousing industry is higher than the national average of any other industry.

We want to help keep you safe and productive at the same time.

Here are some of the Top Hazards found by OSHA:

Forklift Dangers

Hazard

About 100 employees are killed and 95,000 injured every year while operating forklifts in all industries. Forklift turnovers account for a significant percentage of these fatalities.

Solutions

  • Train, evaluate and certify all operators to ensure that they can operate forklifts safely;
  • Do not allow anyone under 18 years old to operate a forklift;
  • Properly maintain haulage equipment, including tires;
  • Before using a forklift, examine it for hazardous conditions which would make it unsafe to operate;
  • Follow safe procedures for picking up, putting down and stacking loads;
  • Drive safely, never exceeding 5 mph and slow down in congested areas or those with slippery surfaces;
  • Ensure that the operator wears a seatbelt installed by the manufacturer;
  • Never drive up to a person standing in front of a fixed object such as a wall or stacked materials;
  • Prohibit stunt driving and horseplay;
  • Do not handle loads that are heavier than the weight capacity of the forklift;
  • Remove unsafe or defective trucks from service until the defect is properly repaired;
  • Maintain sufficiently safe clearances for aisles and at loading docks or passages where forklifts are used;
  • Ensure adequate ventilation either by opened doors/windows or using a ventilation system to provide enough fresh air to keep concentrations of noxious gases from engine exhaust below acceptable limits;
  • Provide covers and/or guardrails to protect workers from the hazards of open pits, tanks, vats and ditches;
  • Train employees on the hazards associated with the combustion byproducts of forklift operation, such as carbon monoxide.


Docks

Hazard

Injuries happen here when forklifts run off the dock, products fall on employees or equipment strikes a person.

Solutions

  • Drive forklifts slowly on docks and dock plates;
  • Secure dock plates and check to see if the plate can safely support the load;
  • Keep clear of dock edges and never back up forklifts to the dock’s edge;
  • Provide visual warnings near dock edges;
  • Prohibit “dock jumping” by employees;
  • Make sure that dock ladders3. Electrical, wiring methods


Conveyors

Hazard

Workers can be injured when they are caught in pinch points or in the in-going nip points, are hit by falling products or develop musculoskeletal disorders associated with awkward postures or repetitive motions.

Solutions

  • Inspect conveyors regularly;
  • Ensure that pinch points are adequately guarded;
  • Develop ways of locking out conveyors and train employees in these procedures;
  • Provide proper lighting and working surfaces in the area surrounding the conveyor.


Charging Stations

Hazard

Fires and explosion risks are possible unless proper guidelines are followed.

Solutions

  • Prohibit smoking and open flames in and around charging stations;
  • Provide adequate ventilation to disperse fumes from gassing batteries;
  • Ensure that fire extinguishers are available and fully charged;
  • Provide proper personal protective equipment such as rubber gloves and eye and face protection;
  • Properly position forklifts and apply brakes before attempting to change or charge batteries; follow required procedures when refueling gas or propane fueled forklifts;
  • Provide conveyors, overhead hoists or equivalent materials handling equipment for servicing batteries;
  • Provide an eye washing and safety shower facility for employees exposed to battery acids.


Poor Ergonomics

Hazard

Improper lifting, repetitive motion or poor design of operations can lead to musculoskeletal disorders in workers.

Solutions

  • If possible, use powered equipment instead of requiring a manual lift for heavy materials;
  • Reduce lifts from shoulder height and from floor height by repositioning the shelf or bin;
  • Ensure overhead lighting is adequate for the task at hand;
  • Provide employees with task-oriented ergonomic training;
  • Use your legs and keep your back in a natural position while lifting;
  • Test the load to be lifted to estimate its weight, size and bulk, and to determine the proper lifting method;
  • Get help if the load exceeds the maximum weight a person can lift safely without assistance;
  • Don’t twist while carrying a load, but shift your feet and take small steps in the direction you want to turn;
  • Keep floors clean and free of slip and trip hazards.

In every facility safety training should not be taken lightly. It is imperative not only to your own safety, but to your coworkers’ as well. At KMH we offer safety training and any equipment checks and repairs you need. Call 888-564-7978 for your free operational audit so we can help you keep everyone safe.

Request Your FREE Operational Audit…

Blue Safety LED Light

Safety issues are a concern for any forklift operator.

According to the US CDC agency, there are nearly 19,000 forklift/pedestrian accidents each year in the United States alone. The Blue Safety LED Light helps minimize forklift/pedestrian accidents by projecting a clear blue spot on the ground behind the forklift. Backup alarms are effective, but what happens when employees are listening to music, talking on cell phones, or just not paying attention?

Blue Safety LED Light can fit on most forklifts to ensure that little extra safety. Relatively new to the industry, they are quickly becoming a mandatory and offer some very unique advantages over backup alarms and other devices.

Blue Safety Lights are ideal for your budget – because accidents are never productive. The Blue LEDs save you time, the cost of unnecessary loss due to collisions and prevent needless worries. They are built using ultra bright LEDs which are so long lasting they can be considered a lifetime bulb thus saving on maintenance, replacement and parts costs. Blue Lights are easily installed on the front or back of any forklift, sweeper or other piece of industrial equipment and have a rugged aluminum housing to resist dust and temporary emersion in water.

The forklift is typically the most dangerous piece of equipment in any facility that uses it, these low-cost enhancements are sensible and easy.

Contact us today for pricing or to learn more about the Blue LED Safety Lights…

Forklift Operator Training

Benefits of Operator Training

There is a distinct difference between teaching someone safe forklift operation and truly training them how to perform the function safely and effectively. KMH gives the highest level of in-depth training for you and your operators in order to keep everyone safe and in alignment with all regulations.

Proper training will also lower your costs in terms of less damage to your products,to your facility, and to operator injury. We teach you how to see small maintenance issues and fixing them before become big ones. Knowing proper methods of operating a forklift also results in less wear and tear on your equipment. All of this results in equipment that stays in better condition for a longer period of time, an increase in useful life of your forklifts, and lower operating costs.

OSHA and ANSI have requirements regarding forklifts. Ultimately it is up to you, the employer, to see that your operators and fleet managers are aware of the regulations and that your company is in compliance.

Operators that receive ongoing training are more efficient at operating your forklifts. This efficiency translates into more productive employees. Improved morale and efficiency gained from training will increase how much work each of your operators can accomplish in a day, and that improves your bottom line.
These best practices decrease the likelihood of injuries to operators and damage to equipment and property.

When observing an operator using material handling equipment, ask the following:

  • Is the driver wearing a seat belt?
  • Is the operator driving at safe speeds?
  • Does the driver sound the horn when approaching blind spots, end of aisles or backing up?
  • When transporting a load, is the load 6” to 10” off of the floor?
  • Is the driver’s visibility blocked?
  • Does the operator use a spotter when the load is blocking his visibility?

Companies that do not emphasize safety and ongoing training of their drivers are easy to spot with this quick observation.

KMH continually strives to educate our customers about lift truck operation, safety, and industrial regulations for both ANSI and OSHA. With proper forklift training, you can reduce your downtime due to improper operation and provide effective timely maintenance/repair of your lift truck fleet. We provide a range of forklift training classes at progressive levels to meet your needs!

Request More Information On Our Operator Training Programs…